.png)
HSI Thick Film Quality
Our philosophy is simple: Quality cannot be inspected into a product. It must originate with the initial design, and continue throughout all other manufacturing and supporting functions. Our Quality requirements are fulfilled when the customer receives a highly-reliable product in full conformance with all applicable specifications and inside the requested delivery date.
Quality Assurance is the basis for our confidence in the reliability of your hybrid circuit. Our team utilizes Dektak3 equipment to measure material thickness as small as 5,000 Angstroms. Our staff undergoes an intensive training program that focuses on:
-
Post-delivery evaluation
-
Vendor evaluation
-
Material analysis and qualification
-
Equipment calibration
-
Process auditing
-
Product performance monitoring
Quality Control is rigorous and consistent. Our inspectors are trained to act as your representative during the manufacturing process and perform:
-
Incoming inspection
-
In-process inspection
-
Final Electrical and Mechanical
-
Certificates of Compliance
HSI is committed to a socially-responsible supply chain and committed to supporting RoHS, REACH, and Conflict Materials protection.
Industry Standards
-
Manufacturing & Quality adheres to the following Aerospace and Military standards:
-
AS-9100, Rev. D
-
AS-9003, Rev. A
-
MIL-STD-883
-
MIL-I-45208
-
MIL-M-38510
-
MIL-C-45662
-
MIL-Q-9858
Quality Management Systems
Inspection and Test Quality Systems
Tests and procedures, microelectronics
Quality
General microcircuits
Calibration
Quality Program
-
For High Reliability applications, additional MIL-STD-883 screening can be performed:
-
Stabilization bake
-
Temperature cycling
-
Thermal shock
-
Constant acceleration
-
Fine and gross leak
-
Final electrical testing
Method 1008
Method 1010
Method 1011
Method 2001
Method 1014
(customer specified)
-
Certified to Cybersecurity requirement NIST SP 800-171 to meet standards required by Department of Defense (DoD) suppliers.
-
Qualified as Lockheed Martin sole-source supplier for thick film multilayer and resistor networks.
-
CAGE Code: 07CB1
Made in USA
Our products are 100% manufactured and sourced in the United States of America except for rare circumstances specified by the customer. CAGE Code: 07CB1.
RoHS
Products comply with EU Directive 2015/863 RoHS 3 Annex III 7c-I and 34 Category 9 per data provided by raw material suppliers. Purchased materials are not subjected to chemical analysis.
REACH
Products are in conformance with REACH - Regulation (EC) No 1907/2006 of the European Parliament and of the Council of 18 December 2006, as updated 17 December 2014.
Conflict Minerals
Products conform with Dodd-Frank Wall Street Reform & Consumer Protection Act of 2010 with no materials sourced from Democratic Republic of the Congo or adjoining countries.